Vinyl siding is undoubtedly one of the most common exterior building materials today. In fact, more than 2 billion sq. ft of sidings. Thousands of homeowners prefer vinyl sidings to other materials because it is affordable, practical, durable, flexible, and easy to maintain.
Also, sidings easy to install. You only need to have the right equipment and patience. Vinyl siding fitting in Oshawa will be completed in a matter of hours even if you are not skilled.
As mentioned above, the siding installation requires the right equipment. Do not worry about spending a lot of money because all you need are basic tools such as a hammer, tape measure, level, chalk line, utility knife, framing square, tin snips, caulk, and guns, cutting or sewing table, and a saw with a fine blade.
To start the installation of vinyl siding, you must prepare the surface that would have applied siding. It should be clean, so wash the walls thoroughly to remove dirt and debris. It should also be solid and smooth.
Image Source: Google
Make sure that the energy leaks sealed and cracks around doors and windows are caulked. If you want to increase energy efficiency, you can install foil-based foam sheathing. This is especially recommended if you install vinyl siding over wood or brick surfaces exist.
Then, the starter strip should be installed at the base of the exterior wall siding panel lowest you so you will be covered properly. You have to start at the bottom and finish on top. Remember that your siding pieces interlock with each other; and made the mistake will mess up the whole vinyl siding installation process.
In addition, the corner cap should be installed in every corner where the walls of the house to meet you. The cap acts as a vertical line that covers joints siding panels and a good result in the end.